PRECISION EQUIPMENT
GENERAL Stair Gage Set MADE IN USA
DESCRIPTION The Stair Gage Set adds an extra dimension to a standard rafter square, allowing you to make uniform layouts for angle cuts. This tool is a must have for laying out rafter and stair stringers, and cuts down on time wasted making repetitive measurements. Features: Brass plated steel stair gage assures fast and uniform layout in repetitive work including angle cuts on rafters and stair stringers Attaches easily to all metal rafter squares Set of 2 pieces
- FAST & UNIFORM LAYOUTS – Speed up any measuring job, with better accuracy! Ideal for repetitive work such as cuts on rafters, stringers, or any type of stairway work
- UNIVERSAL FOR ANY SQUARE – Easily clamps to any metal framing, rafter or carpenter squares. An essential woodworking tool - no square should be without a set
- DURABLE & RUST RESISTANT – Brass plated steel for lifetime use and rust resistance
- EASY TO USE – After measurements, simply tighten the tops onto the square to use as references. The knurled screws allows for fast and easy adjustments
0.4" TO 0.7" DIAL BORE GAGE SET
.
2.4 bore depth
9 anvils
This dial-type cylinder bore gauge set has a 2" to 6" range that can cover most motorcycle and automotive engines. Don't even think of buying a used engine block or jugs for your bike without using one of these babies to check things out first.
Comes with fitted carrying case.
Graduation: 0.0005"
AO645187 1.4 TO 2.4 DIAL BORE GAGE SET
6 bore depth. 6 anvils. This dial-type cylinder bore gauge set has a 2" to 6" range that can cover most motorcycle and automotive engines. Don't even think of buying a used engine block or jugs for your bike without using one of these babies to check things out first. Comes with fitted carrying case. Graduation: 0.0005"
- 2-6" inch range
- 6" bore depth
- 3pc washers and 11 pc Anvils (1 anvil installed in the bore gage probe and 10 pc in case slot),No product for two slots is correct.
- Size includes: 4.0'', 3.8'', 3.6'', 3.4'', 3.2'', 3.0'', 2.8'', 2.6'', 2.4'', 2.2'', 2.0''
- Grad. 0.0005“ Self-centering measuring heads, chrome plated handle and includes extension holder and good quality fitted case
MS121 Toolmaker's Surface Gage (2 spindles 9" & 12") • Base and scriber are hardened • Bottom grooved for cylindrical work • Front recessed for depressing spindle below base level • Features fine adjustment • Base has 2 retractable gage pins to set against edge of a surface plate
Designed to measure outer thickness. Ideally suited for quick inspection of paper, leather, wire, plastic, sheet metal etc. Measuring faces are finely ground for precise measurement to .001" or .02mm. Dial Reading 0 - 100.
FEATURES:
- . 0-1/2" Range .
- .0005" graduation
- Dial reading: 0-100.
- Throat capacity: .500"